Digi IX14

Applications Digidevice module
IX14 User Guide
487
5. Print the location data in json format:
>>> geojson_data = location.Location().geojson
>>> print(json.dumps(geojson_data, indent=4))
{
"type": "Feature",
"geometry": {
"type": "Point",
"coordinates" [
44.926195299999998,
-93.397084499999999,
273.20001200000002
]
},
"properties": {
"direction": "None",
"horizontal_velocity": "0.0",
"latitude.deg_min_sec": "44* 54' 45.586\" N",
"longitude.deg_min_sec": "93* 33' 52.334\" W",
"num_satellites": "12",
"quality": "Standard GNSS (2D/3D)",
"selected_source_idx": "0",
"source": "USB (/dev/ttyACM0)",
"source_idx.0.altitude": "273.200012",
"source_idx.0.direction": "None",
"source_idx.0.horizontal_velocity": "0.195489",
"source_idx.0.label": "usb",
"source_idx.0.latitude": "44.902662",
"source_idx.0.latitude.deg_min_sec": "44* 55' 45.065\" N",
"source_idx.0.longitude": "-93.560648",
"source_idx.0.longitude.deg_min_sec": "93* 16' 52.966\" W",
"source_idx.0.num_satellites": "12",
"source_idx.0.quality": "Standard GNSS (2D/3D)",
"source_idx.0.utc_date_time": "Mar-03-2022 10:16:23",
"source_idx.0.vertical_velocity": "0.0",
"source_idx.1.label": "gnss",
"source_idx.1.quality": "No Fix / Invalid",
"state": "Enabled, signal",
"utc_date_time": "Mar-03-2022 10:16:23",
"vertical_velocity": "0.0"
}
}
>>>
6. Use Ctrl-D to exit the Python session. You can also exit the session using exit() or quit().
Help for the digidevice location module
Get help for the digidevice location module:
1. Log into the IX14 command line as a user with shell access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type shell to access the device shell.