Applications Digidevice module
IX14 User Guide
491
4. Click to enable Allow scheduled scripts to handle SMS.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> system schedule sms_script_handling true
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
See Configure scripts to run automatically for more information about scheduling scripts.
Example digidevice.sms code
The following example code receives an SMS message and sends a response:
#!/usr/bin/python3.6
To Next Page
Loading...
Need help?
General
