Central management Configure Digi Remote Manager
IX14 User Guide
502
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Digi Remote Manager support is enabled by default. To disable Digi Remote Manager support:
(config)> cloud enable false
(config)>
4. (Optional) Set the service:
(config)> cloud service value
(config)>
where value is either:
n
drm: Digi Remote Manager
n
aview: Digi aView
The default is Digi Remote Manager.
5. (Optional) Set the URL for the central management server. The default is the Digi Remote
Manager server, my.devicecloud.com.
(config)> cloud drm drm_url url
(config)>
6. (Optional) Set the amount of time that the IX14 device should wait before reattempting to
connect to the remotecloud services after being disconnected. The minimum value is ten
seconds. The default is 30 seconds.
(config)> cloud drm retry_interval value
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set the retry interval to ten minutes, enter either 10m or 600s:
(config)> cloud drm retry_interval 600s
(config)>
7. (Optional) Set the amount of time that the IX14 device should wait between sending keep-alive
messages to the Digi Remote Manager when using a non-cellular interface. Allowed values are
from 30 seconds to two hours. The default is 60 seconds.
(config)> cloud drm keep_alive value
(config)>
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set the keep-alive interval to ten minutes, enter either 10m or 600s:
To Next Page
Loading...
Need help?
General
