To Next Page

To Previous Page

Virtual Private Networks (VPN) IPsec

IX14 User Guide

558

Metric: 20

Local endpoint > Interface: LAN

Remote endpoint > Hostname: 192.168.10.1

In this configuration:

1. Tunnel_1 will normally be used for traffic destined for the 192.168.10.1 endpoint.

2. If pings to 192.168.10.2 fail, SureLink will shut down the tunnel and renegotiate its IPsec

connection.

3. While Tunnel_1 is down, Tunnel_2 will be used for traffic destined for the 192.168.10.1

endpoint.

WebUI

1. Configure the primary IPsec tunnel. See Configure an IPsec tunnel for instructions.

During configuration of the IPsec tunnel, set the metric to a low value (for example, 10).

Configure SureLink for the primary IPsec tunnel and enable Restart interface. See

Configure SureLink active recovery for IPsec for instructions.

2. Create a backup IPsec tunnel. Configure this tunnel to use the same local and remote

endpoints as the primary tunnel. See Configure an IPsec tunnel for instructions.

During configuration of the IPsec tunnel, set the metric to a value that is higher than the

metric of the primary tunnel (for example, 20).

Command line

Digi IX14 User Manual

Questions and Answers: