Virtual Private Networks (VPN) OpenVPN
IX14 User Guide
613
1. Log into the IX14 WebUI as a user with Admin access.
2. On the menu, select Status > OpenVPN >Clients.
The OpenVPN Clients page appears.
3. To view configuration details about an OpenVPN client, click the ï‚ (configuration) icon in the
upper right of the OpenVPN client's status pane.
Command line
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured OpenVPN clients, type the following at the prompt:
> show openvpn client all
Client Enable Status Username Use File Zone
--------------- ------ ------- -------- -------- --------
OpenVPN_Client1 true connected true internal
OpenVPN_Client2 true pending true internal
>
3. To display details about a specific client:
> show openvpn client name OpenVPN_client1
Client : OpenVPN_client1
Enable : true
Status : up
Username : user1
IP address : 123.122.121.120
Remote : 120.121.122.123
MTU : 1492
Zone : internal
IP Address : 192.168.30.1/24
Port : 1194
Use File : true
Metric : 0
Protocol : udp
Port : 1194
Type : tun
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
To Next Page
Loading...
Need help?
General
