EasyManuals Logo

Digi IX14 User Manual

Digi IX14
828 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #722 background imageLoading...
Page #722 background image
Routing IP routing
IX14 User Guide
722
Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable routing services:
(config)> network route service enable true
(config)>
4. Configure routing services that will be used:
a. Use the ? to display available routing services:
(config)> network route service ?
Routing services: Settings for dynamic routing services and protocols.
Parameters Current Value
---------------------------------------------------------------------
----------
enable true Enable
zone dynamic_routes Zone
Additional Configuration
---------------------------------------------------------------------
----------
bgp BGP
isis IS-IS
ospfv2 OSPFv2
ospfv3 OSPFv3
rip RIP
ripng RIPng
(config)>
b. Enable a routing service that will be used. For example, to enable the RIP service:
(config)> network route service rip enable true
(config)>
c. Complete the configuration of the routing service. For example, use the ? to view the
available parameters for the RIPservice:
(config)> network route service rip ?
Parameters Current Value

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi IX14 and is the answer not in the manual?

Digi IX14 Specifications

General IconGeneral
BrandDigi
ModelIX14
CategoryNetwork Router
LanguageEnglish

Related product manuals