Routing Virtual Router Redundancy Protocol (VRRP)
IX14 User Guide
738
To configure the VRRP interface:
a. Click to expand Network > Interfaces.
b. Click to expand the appropriate VRRP interface (for example, LAN1).
c. For backup devices, for Default Gateway, type the IP address of the VRRP interface on the
master device.
d. Configure the VRRP interface's DHCP server to use a custom gateway that corresponds to
one of the VRRP virtual IP addresses:
i. Click to expand DHCP Server > Advanced settings.
ii. For Gateway, select Custom.
iii. For Custom gateway, enter the IP address of one of the virtual IPs used by this VRRP
instance.
e. For backup devices, enable and configure SureLink on the VRRP interface. Generally, this
should be a LAN interface; VRRP+ will then monitor the LANusing SureLink to determine if
the interface has network connectivity and promote a backup to master if SureLink fails.
i. Click to expand IPv4 > SureLink.
ii. Click Enable.
iii. For Interval, type a the amount of time to wait between connectivity tests. To
guarantee seamless internet access for VRRP+ purposes, SureLink tests should occur
To Next Page
Loading...
Need help?
General
