Digi IX14

Interfaces Wireless Wide Area Networks (WWANs)
IX14 User Guide
77
WebUI
SureLink can be configured for both IPv4 and IPv6.
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Create a new interface or select an existing one:
n
To create a new interface, see Configure a Wireless Wide Area Network (WWAN).
n
To edit an existing interface, click to expand the appropriate interface.
5. After creating or selecting the interface, click IPv4 (or IPv6) > SureLink.
6. Enable SureLink.
SureLink can be enabled for both IPv4 and IPv6 configurations. By default, SureLink is enabled
for IPv4 for the preconfigured WWAN (Modem). It is disabled for IPv6.