Interfaces Wireless Wide Area Networks (WWANs)
IX14 User Guide
82
(config network interface my_wwan ipv4 surelink target 0)>
interface_timeout value
(config network interface my_wwan ipv4 surelink target 0)>
The default is 60 seconds.
l
other: Allows you to test another interface's status, to create a failover or coupled
relationship between interfaces:
(config network interface my_wwan ipv4 surelink target 0)> other
value
(config network interface my_wwan ipv4 surelink target 0)>
If other is set:
o
Set the alternate interface to be tested:
i. Use the ? to determine available interfaces:
(config network interface my_wan ipv4 surelink target
0)> other_interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan
/network/interface/loopback
/network/interface/modem
Current value:
(config network interface my_wan ipv4 surelink target
0)> other_interface
ii. Set the interface. For example:
(config network interface my_wan ipv4 surelink target
0)> other_interface /network/interface/LAN
(config network interface my_wan ipv4 surelink target
0)>
o
Set the alternate interface's IP version. This allows you to determine the
alternate interface's status for a particular IP version.
(config network interface my_wwan ipv4 surelink target 0)>
other_ip_version value
(config network interface my_wwan ipv4 surelink target 0)>
where value is one of: any, both, ipv4, or ipv6.
o
Set the expected status of the alternate interface:
To Next Page
Loading...
Need help?
General
