Interfaces Wireless Wide Area Networks (WWANs)
IX14 User Guide
95
n
auto: Requests both IPv4 and IPv6 address.
n
ipv4: Requests only an IPv4 address.
n
ipv6: Requests only an IPv6 address.
The default is auto.
6. (Optional) Set the authentication method:
(config)> network interface modem modem apn 0 auth method
(config)>
where method is one of the following:
n
none: No authentication is required.
n
auto: The device will attempt to connect using CHAP first, and then PAP.
n
chap: Uses the Challenge Handshake Authentication Profile (CHAP) to authenticate.
n
pap: Uses the Password Authentication Profile (PAP) to authenticate.
If auto, chap, or pap is selected, enter the Username and Password required to authenticate:
(config)> network interface modem modem apn 0 username name
(config)> network interface modem modem apn 0 password pwd
(config)>
The default is none.
7. (Optional) To configure the device to bypass its preconfigured APN list and only use the
configured APNs:
(config)> network interface modem modem apn_lock true
(config)>
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show cellular status and statistics
You can view a summary status for all cellular modems, or view detailed status and statistics for a
specific modem.
WebUI
1. Log into the IX14 WebUI as a user with Admin access.
2. On the menu, click Status.
3. Under Connections, click Modems.
The modem status window is displayed
Command line
To Next Page
Loading...
Need help?
General
