Digi PortServer II

Page 220 Troubleshooting 90030500B
2) not enough memory to start user process
PortServer II does not have sufficient memory available to create a connection.
3) malloc error dialing on port <port>
A memory allocation failed.
4) link task received M_ERROR
An error occurred in a lower layer (possibly the serial driver) and the link will be
aborted.
5) Could not open frame relay driver
*Internal error*
6) <username>:ioctl failed
*Internal error*
7) failed to push PPP module
*Internal error*
8) failed to push VJC module
*Internal error*
9) couldn't open wan driver
*Internal error*
10) unable to get minor number
*Internal error*
11) could not link to wan driver
*Internal error*
12) Wan Interface table exhausted.
*Internal error*
13) No memory for WAN Interface.
PortServer II does not have sufficient memory available for the WAN Interface.