Digi PortServer II

90030500B Troubleshooting Page 221
14) Could not open wan driver.
*Internal error*
15) unable to get minor number
*Internal error*
16) could not link ip to network
*Internal error*
17) could not configure IP
*Internal error*
18) could not get_net_by_id\n");
*Internal error*
19) changestatus ioctl failed
*Internal error*
20) No memory to start frame relay connection for <name>
PortServer II does not have sufficient memory available for the Frame Relay connec-
tion.
21) <name> couldn't send wan close request
*Internal error*
22) Could not pwd_to_userinfo for <name> (memory problem?)
*Internal error*
23) connection manager received M_ERROR
*Internal error*
24) WAN couldn't connect interface to data stream
*Internal error*
25) WAN couldn't send message, port probably locked up!
A serial port may be stuck in one state. Try rebooting PortServer II to clear the prob-
lem. If the condition persists, contact Digi Technical Support.