Digi XBEE-PRO S3B Manual

XBee‐PRO®900HP/XBee‐PRO®XSCRFModules
©2014DigiInternationalInc. 111
NOTE:ATCommandsissuedwithoutaparametervalueareinterpretedasqueriesandwillreturnthecurrentlystoredparameter.
*CommandsonlysupportedonS3Bhardware.
XBee-PRO XSC Command Descriptions
Commands in this section are listed alphabetically. Command categories are designated between the “< >”
symbols that follow each command title. Modules expect numerical values in hexadecimal and those values
are designated by a “0x” prefix.
Modules operating within the same network should contain the same firmware platform to ensure the same AT
Command parameters are supported.
AM (Auto-set MY) Command
AT (Guard Time After) Command

TT 0x1A (26d) Streaming Limit 0 – 0xFFFF [0 = disabled] Networking 2 0xFFFF
VR 0x14 (20d) Firmware Version 0 - 0xFFFF [read-only] Diagnostics 2 -
WR 0x08 (8d) Write - (Special) - -
Command Summary Description
AT Command: ATAM
<Networking & Security> AM Command
is used to automatically set the MY
(Source Address) parameter from the
factory-set module serial number. The
address is formed with bits 29, 28 and
13-0 of the serial number (in that
order).
Binary Command: 0x3A (58 decimal)
This command is only supported on S3B
modules.
Command Summary Description
AT Command: ATAT
<Command Mode Options> AT
Command is used to set the time-of-
silence that follows the command
sequence character (CC Command). By
default, AT Command Mode will activate
after one second of silence.
Refer to the AT Commands section to
view the default AT Command Mode
Sequence.
Binary Command: 0x05 (5 decimal)
Parameter Range:0x02 – 0xFFFF
[x 100 milliseconds]
Number of bytes returned: 2
Default Parameter Value: 0x0A (10
decimal)
Related Commands: BT (Guard Time
Before), CC (Command Sequence
Character)

Digi XBEE-PRO S3B Specifications

General

Brand	Digi
Model	XBEE-PRO S3B
Category	Control Unit
Language	English