XBee‐PRO®900HP/XBee‐PRO®XSCRFModules
©2014DigiInternationalInc. 144
AppendixC:AgencyCertificationsforLegacy
S3/S3BHardware
Please note that both Appendix B and Appendix C contain Agency Certification information. Please refer to the
Preface for instructions on which appendix applies to your product.
FCC (United States) Certification
The XBee-PRO
®
XSC RF Module complies with Part 15 of the FCC rules and regulations. Compliance with the
labeling requirements, FCC notices and antenna usage guidelines is required.
In order to operate under Digi’s FCC Certification, RF Modules/integrators must comply with the following
regulations:
Labeling Requirements
WARNING: The Original Equipment Manufacturer (OEM) must ensure that FCC labeling requirements
are met. This includes a clearly visible label on the outside of the final product enclosure that
displays the text shown in the figure below.
FigureA‐01. RequiredFCCLabelforOEMproductscontainingtheXBee-PRO
®
XSCRFModule.
XBEE PRO S3
OR
XBEE PRO S3B
FCC Notices
IMPORTANT: The XBee-PRO
®
XSC OEM RF Module has been certified by the FCC for use with other products
without any further certification (as per FCC section 2.1091). Modifications not expressly approved by Digi
could void the user's authority to operate the equipment.
IMPORTANT: OEMs must test final product to comply with unintentional radiators (FCC section 15.107 &
15.109) before declaring compliance of their final product to Part 15 of the FCC Rules.
IMPORTANT: The RF module has been certified for remote and base radio applications. If the module will be
used for portable applications, the device must undergo SAR testing.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
1. The system integrator must ensure that the text provided with this device [Figure A-01] is
placed on the outside of the final product and within the final product operation manual.
2. The XBee-PRO
®
XSC RF Module may only be used with antennas that have been tested and
approved for use with this module refer to Table A-1.
Contains FCC ID: MCQ-XBEEXSC
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any inter-
ference received, including interference that may cause undesired operation.
Contains FCC ID: MCQ-XBPS3B
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any inter-
ference received, including interference that may cause undesired operation.
To Next Page
Loading...
Need help?
General
