XBee‐PRO®900HP/XBee‐PRO®XSCRFModules
©2014DigiInternationalInc. 145
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures: Re-orient or relocate the receiving antenna, Increase the separation between the
equipment and receiver, Connect equipment and receiver to outlets on different circuits, or Consult the dealer
or an experienced radio/TV technician for help.
Limited Modular Approval
This is an RF module approved for Limited Modular use operating as a mobile transmitting device with respect
to section 2.1091 and is limited to OEM installation for Mobile and Fixed applications only. During final
installation, end-users are prohibited from access to any programming parameters. Professional installation
adjustment is required for setting module power and antenna gain to meet EIRP compliance for high gain
antenna(s).
Final antenna installation and operating configurations of this transmitter including antenna gain and cable
loss must not exceed the EIRP of the configuration used for calculating MPE. Grantee (Digi) must coordinate
with OEM integrators to ensure the end-users and installers of products operating with the module are
provided with operating instructions to satisfy RF exposure requirements.
The FCC grant is valid only when the device is sold to OEM integrators. Integrators are instructed to ensure
the end-user has no manual instructions to remove, adjust or install the device.
FCC-approved Antennas
WARNING: This device has been tested with Reverse Polarity SMA connectors with the antennas
listed in the tables of this section. When integrated into OEM products, fixed antennas require
installation preventing end-users from replacing them with non-approved antennas. Antennas not
listed in the tables must be tested to comply with FCC Section 15.203 (unique antenna connectors)
and Section 15.247 (emissions).
Fixed Base Station and Mobile Applications
Digi RF Modules are pre-FCC approved for use in fixed base station and mobile applications. When the antenna
is mounted at least 20cm (8") from nearby persons, the application is considered a mobile application.
Portable Applications and SAR Testing
If the module will be used at distances closer than 20cm to all persons, the device may be required to undergo
SAR testing. Co-location with other transmitting antennas closer than 20cm should be avoided.
RF Exposure
This statement must be included as a CAUTION statement in OEM product manuals.
WARNING: This equipment is approved only for mobile and base station transmitting devices.
Antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
IC (Industry Canada) Certification
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1)
To Next Page
Loading...
Need help?
General
