XBee‐PRO®900HP/XBee‐PRO®XSCRFModules
©2014DigiInternationalInc. 81
Commissioning Pushbutton and Associate LED
The XBee modules support a set of commissioning and LED behaviors to aid in device deployment and
commissioning. These include the commissioning push button definitions and associate LED behaviors. These
features can be supported in hardware as shown below.
CommissioningPushbuttonandAssociateLEDFunctionalities
Commissioning Pushbutton
The commissioning pushbutton definitions provide a variety of simple functions to aid in deploying devices in a
network. The commissioning button functionality on pin 20 is enabled by setting the D0 command to 1
(enabled by default).
Button Presses
Sleep
Configuration and
Sync Status
Action
1 Not configured for sleep
Immediately sends a Node Identification
broadcast transmission.
All devices that receive this transmission will
blink their Associate LED rapidly for 1 second.
All API devices that receive this transmission
will send a Node Identification frame out their
serial interface (API ID 0x95)
1 Configured for asynchronous sleep
Wakes the module for 30 seconds. Immediately
sends a Node Identification broadcast
transmission. All devices that receive this
transmission will blink their Associate LED
rapidly for 1 second. All API devices that receive
this transmission will send a Node Identification
frame out their serial interface (API ID 0x95).
1 Configured for synchronous sleep
Wakes the module for 30 seconds (or until the
entire module goes to sleep). Queues a Node
Identification broadcast transmission to be sent
at the beginning of the next network wake cycle.
All devices that receive this transmission will
blink their Associate LEDs rapidly for 1 second.
All API devices that receive this transmission
will send a Node Identification frame out their
serial interface (API ID 0x95).
2 Not configured for synchronous sleep No effect.
2 Configured for synchronous sleep
Causes a node which is configured with
sleeping router nomination enabled (see
description of the ATSO – sleep options
command in the XBee module’s Product
Manual) to immediately nominate itself as the
network sleep coordinator.
XBee
20
15
Push button
R
Associate
LED
A pushbutton and an LED can be connected to module pins 20 and 15 respectively to
support the commissioning pushbutton and associated LED functionalities.