XBeeāPROĀ®ī ±900HP/XBeeāPROĀ®ī ±XSCī ±RFī ±Modules
Ā©ī ±2014ī ±Digiī ±Internationalī ±Inc. ī ±ī ±ī ±ī ±ī ±127
TT (Streaming Limit) Command
Command Summary
Description
AT Command: ATTT <Networking> TT Command defines a
limit on the number of bytes that can
be sent out before a random delay is
issued. TT Command is used to simulate
full-duplex behavior.
If a module is sending a continuous
stream of RF data, a delay is inserted
which stops its transmission and allows
other modules time to transmit
(once it sends number of bytes specified
by TT Command). Inserted random
delay lasts between 1 & āRN + 1ā delay
slots, where each delay slot
lasts 38 ms.
Binary Command: 0x1A (26 decimal)
Parameter Range:0 ā 0xFFFF (0 =
disabled)
Default Parameter Value: 0xFFFF (65535
decimal)
Number of bytes returned: 2
Related Commands: RN (Delay Slots)
To Next Page
Loading...
