Need help?Do you have a question about the digico SD12 and is the answer not in the manual?
Explains the IP addresses for the console PC and host interface controller.
Describes how the worksurface is divided into layers and banks, and how to navigate them.
Explains how to navigate and operate the console using the touchscreen and physical controls.
Describes the four different channel types available on the SD12 worksurface.
Provides an overview of connecting the console to racks using MADI and optical fibre.
Guides on defining channel types, counts, and bus configurations for a new session.
Details how to configure physical audio I/O, including racks, cards, and sockets.
Explains how to perform input and output routing using various displays and methods.
Explains the EQ section with parametric filters and dynamic control.
Covers compressor, gate, de-esser, and multiband compressor modules for channel dynamics.
Provides step-by-step instructions on how to install DMI cards into the SD12.
Explains how to connect MADI DMI cards using BNC or Cat5e for various rack types.
General| Sample Rate | 96 kHz |
|---|---|
| Dynamic EQ | Yes |
| Multiband Compressors | Yes |
| Touchscreens | 2 x 15-inch touchscreens |
| Effects | Built-in effects |
| EQ | 4-band parametric EQ |
| Processing | FPGA processing |
| Connectivity | Dante |
| Local I/O | 8 Mic/Line Inputs, 8 Line Outputs |
To Next Page
