Digifly AIR-BT - Manual Page Switching

AIR_Manual_506a_ENG_rev_1.pdf Page 12/96
3.2.2
MANUAL PAGE SWITCHING
 To manually change the pages, press the key to go forward or the key to go back.
You can manually switch pages even if you are in “Intellifly” mode.
3.2.3
AUTOMATIC PAGE SWITCHING (INTELLIFY)
 The automatic page-switching among the different pages is automatically managed by the
Intellifly
system,
which recognizes the type of in-flight situation you are in at all times.
 Each type of in-flight situation is associated to a different set of pages (2 per set):
Pages 1 and 2 are associated to a “Competition flying while navigating towards a standard waypoint” situation.;
Pages 3 and 4 are associated to a “Competition flying while navigating towards a Start waypoint”;
Pages 5 and 6 are associated to a “Competition flying while navigating towards a Goal waypoint”;
Pages 7 and 8 are associated to a “Free Cross Country flying” situation;
 Each set of pages is formed by a “THERMAL” and a “GLIDE” version. The automatic page switching within each
set of pages follows these criteria: It will switch to the “THERMAL” page when it notices a thermal that lasts
longer than the value set on the
VARIOMETER SETUP\ n. 17 THET
parameter (default setting 2 seconds) and
you make a turn to fly into it; it will switch to the “GLIDE” page when you fly “straight” for a period of time,
longer than the value set on the
VARIOMETER SETUP\ n. 16 CRUT
(default setting 15 seconds).
 The
MAIN SETUP\ n. 38 IFLY
parameter sets the mode in which the Intellifly system will work :
o
IFLY=OFF
: automatic page switching is disabled.
o
IFLY=CMP
:
automatic page switching is in “Competition” mode
:
when your current wpt is a standard one, it will automatically switch between PG01 and PG02;
when your current wpt is the START, it will automatically switch between PG03 and PG04;
when your current wpt is the one before last on your route (GOAL), it will automatically switch between
PG05 and PG06.
If I manually switch to a page outside the PG01-PG06 range, while on IFLY = CMP mode, the automatic
switching will be paused until I manually switch back to one of the pages of the PG01-PG06 range.
Remember to verify that all 6 competition pages are active:
MAIN SETUP\ n.26 PG01
to
MAIN SETUP\
n.31 PG06
=
STD
or
USR
(in case you have uploaded your own pages).
o
IFLY=XC
: automatic page switching will be on “Cross Country” mode (default setting): it will automatically
switch between PG07 e PG08.
PG07 is the XC – Thermal page and PG08 is the XC – Glide page.
If I manually switch to a page different from PG07 or PG08, the automatic page switching mode will be
paused until I manually switch back to a page among PG07 or PG08.
Remember to check that the 2 Cross Country pages are active:
MAIN SETUP\ n.32 PG07
and
MAIN
SETUP\ n.33 PG08
on
STD
or
USR
(in case you have uploaded your own pages).