Digifly AIR-BT - Recording Rate

AIR_Manual_506a_ENG_rev_1.pdf Page 62/96
11.2
RECORDING RATE
 The recorder rate can be adjusted from 1 to 60 seconds, go to:
MAIN SETUP \ n.6 RECR
).
 Setting 1 data point per second, will record over 30 hours of flight data.
 Setting 1 data point per minute, will record up to 1800 hours of flight data.
 The recorder memory has room for up to 100,000 GPS data points and up to 250 flights.
 When you are 100m from a Waypoint, the recorder rate is automatically increased to 1 data point per second.
 When the recorder’s memory is full, the oldest flight is automatically deleted by the newest one.
 The remaining free memory time and percentage are shown for 2 seconds as the instrument is turned on, or for
as long as the power button is pressed when turning the instrument on.
 If a single flight fills the whole memory, it is not possible to use the recorder anymore. The “MEM FULL”
message appears every time that you try to use it. To activate the flight recorder again, it is necessary to clear
the entire recorder memory. To do this: go to
MENU
\
LOGBOOK
LONG PRESS
the key and confirm the
cancellation of ALL FLIGHTS by pressing the key, or cancel the procedure using the key .
11.3
LOG BOOK MANAGEMENT (LOG BOOK)
 To see the recorded flights, select the menu “LOGBOOK”. The list of all the recorded flights will be displayed
with their date and take off time.
 To see details of each recorded flight, select a flight the press the key. For every flight the following
information is displayed:
o Take off date and time, flight duration, and total altitude gain.
o Max. and min. values for A1 Altimeter and Variometer
o Max values for Ground speed GPS and Indicated Airspeed (IAS)
 To delete all the flights : from the menu “LOGBOOK
LONG PRESS
the key and confirm the cancellation of
ALL THE FLIGHTS by pressing the key, or cancel the procedure using the key.
 It is not possible to delete a single flight.
Suggestion
: It is a good practice to clear up your flight memory before the start of a competition. You can save
your flights on your computer before doing this.
11.4
INTEGRATED IGC FILE
 INTEGRATED IGC FILE (formatted according to the
FAI-CIVL Cat 1
regulations)
Automatically generates an IGC file with G-Record signature directly on the microSD card, in the \IGC folder. If
the folder is not yet on the microSD, it will be created automatically.
 How to use: Go to Menu \ Logbook, select the desired flight, then LONG PRESS the button.
 The help message under “Logbook” will say “long press OK to save IGC”