Digital Projection E-Vision Laser 5000 XGA - Installation and Basic Setup; Projector Installation Notice

Digital Projection Preface
E-VISION LASER 5000 SERIES USER MANUAL REV A JANUARY 2018
vii
Projector Installation Notice
 There is no limitation angle for projector installation.
 Allow at least 50 cm clearance around the exhaust vent.
 Ensure that the intake vents do not recycle hot air from the exhaust vent.
 When operating the projector in an enclosed space, ensure that the surrounding air temperature
within the enclosure does not exceed the projectors operational temperature range whilst the
projector is running, and that the air intake and exhaust vents are unobstructed.
 All enclosures should pass a certified thermal evaluation to ensure that the projector does not
recycle exhaust air, as this may cause the projector to shutdown even if the enclosure temperature
is with the acceptable operational temperature range.
Minimum 500mm
(19.69 inch)
Minimum 500mm
(19.69 inch)
Minimum 500mm
(19.69 inch)
Minimum 500mm
(19.69 inch)
Minimum 300mm
(11.81 inch)
Minimum 100mm
(3.94 inch)
Minimum 500mm
(19.69 inch)
Minimum 500mm
(19.69 inch)