Digital Projection E-Vision Laser 5000 XGA - Verify the Installation Location; Cooling Notes

Digital Projection
E-VISION LASER 5000 SERIES USER MANUAL REV A JANUARY 2018
viii
Verify the Installation Location
 To supply power, a 3-blade (with Earth) socket should be used to ensure proper grounding and an
equalized ground potential for all of the equipment in the Projector System.
 The 3-blade power cord provided with the Projector should be used.
 Other qualified 3-blade (with Earth lead) power cords can be used as a substitution for the supplied
power cord; however do not use a 2-blade power cord.
 Verify if the voltage is stable, grounded properly and there is no electrical leakage.
 Measure the total power consumption which should not higher than the safety capacity of the
system and avoid safety issues and short circuits.
 Turn on “Altitude Mode” when the projector is located in high altitude areas.
 When installed using a projector mounting bracket, make sure that the manufacturers certified
weight limit of the mounting bracket is not exceed and that the mounting bracket is firmly secured.
 Avoid installing near an air conditioner duct or a subwoofer where airflow can be affected.
 Avoid installing in high temperature, insufficient cooling and dusty locations.
 Keep your product away from fluorescent lamps
(>1 Metre) to avoid any malfunctions
caused by Infrared (IR) interference
 The VGA IN connector should be connected to the VGA IN port. Note that it should be inserted
tightly, with the screws on both sides securely fastened to ensure a proper connection of the signal
wire for achieving an optimal display.
 The AUDIO IN connector should be connected to the AUDIO IN port only and CANNOT be
connected to the AUDIO OUT or other ports (BNC, RCA); otherwise, it will lead to a muted output
and can even DAMAGE the port.
 The power cord and signal cables should be connected before powering on the projector.
 During the projector starting and operating process, DO NOT insert or remove signal cables or the
power cord to avoid damaging the projector.
Cooling notes
Air outlet
 Make sure the air exhaust outlet is 50 cm clear of any obstruction to ensure sufficent cooling.
 The projectors air exhaust outlet locations should not be located in front of the lens of another
projector to avoid causing image distortions on the other projectors image.
 Keep the air exhaust outlet at least 1 Metre away from the air inlets of other projectors
 The projector generates heat during use. The internal fans continue to dissipate this heat during
the shutting down process, this process will continue for a period of time to ensure the projector
has cooled sufficiently. After the projector enters STANDBY mode you can then remove the power
cord from the projector.
 DO NOT remove the power cord during the shutdown process, as it may cause damage to the
projector and the delayed heat radiating within the unit will also affect the service life of the
projector. The shutdown process may vary depending on the projector model used. Whatever the
case may be, be sure to not disconnect the power cord till until after the projector enters the
STANDBY mode.
Air inlet
 Make sure there is no object blocking an air input within 30 cm.
 Keep the air inlet away from other heat sources.
 Avoid dusty environments.