Digitalchina Networks DCS-3950 series User Manual

69
DCS-3950 series Ethernet switch manual
permission can be set through ro|rw. ro is for read only while rw for read/write.
Usage Guide: Up to 4 community strings are supported by the switch.
Example:
Setup a community string as private with read/write permission.
Switch(config)#snmp-server community rw private
Setup a community string as public with read only permission.
Switch(config)#snmp-server community ro public
Change the permission of private to read only.
Switch(config)#snmp-server community ro private
Remove the community string named private.
Switch(config)#no snmp-server community private
5.4.4.2.3 snmp-server enable traps
Command：snmp-server enable traps
no snmp-server enable traps
Function: Enable the switch to send the Trap messages. If no is put in front of this
command, the configuration will be disabled.
Command mode: Global Mode.
Default: Trap messages are disabled by default.
Usage Guide: When Trap messages are enabled, Trap messages will be sent when the
interfaces or the system become down/up.
Example:
Enable the trap messages.
Switch(config)#snmp-server enable traps
Disable the trap messages.
Switch(config)#no snmp-server enable trap
5.4.4.2.4 snmp-server engineid
Command: snmp-server engineid <engine-string>
no snmp-server engineid <engine-string>
Function: Configure the engine id for SNMP server. If no is put in front of this command,
the engine id configuration will be disabled
Command mode: Global Mode.
Parameters: <engine string> is the engine id, which is presented in lexical characters with
the length of 10.
Default: Corporation ID + local MAC address is configured by default.
Example: Configure the engine id as A66688000F.
Switch(config)#snmp-server engineid A66688999F
Recover the default engine id configuration.
Switch(config)#no snmp-server engineid A66688999F

Digitalchina Networks DCS-3950 series Specifications

General

Brand	Digitalchina Networks
Model	DCS-3950 series
Category	Network Router
Language	English