USING THE TUNER
When using the Tuner of the 2112, it can be accessed one of two ways. Either by pressing the <Tuner> button on the
front panel or using the optional Control One foot controller.The following, explains both modes of operation.
Front Panel
• Press the <Tuner> button.The display reads:
.• As you play a note on the guitar, the top line will tell you which note you are playing, while the meter will show you
if you are flat or sharp. If the meter is moving right, the note you are playing is sharp. If the meter moves left, you
are flat.The goal is to tune your guitar so that the meter stops moving, and the display will lock-in, indicating that
you are in tune. Once you start playing the selected note, the display will read as follows:
• Press the <Tuner> button to exit the Tuner mode.
Reference and Output
The 2112 gives you the option of changing the Tuning reference from F# to 453, by simply turning the <3> knob while
the 2112 is in Tuner mode. Another feature available in the 2112 Tuner mode, is the ability to set the amount of signal
that is passed to the output while tuning.This has a range from 0 (mute) to 100%.The output can be changed by turn-
ing the <4> to the desired level while the 2112 is in Tuner mode.
Control One Tuner Mode
To access the Tuner mode using the optional Control One foot controller, press and hold the Bank Up/Tuner
footswitch to engage tuner mode on the Control One.
• As you play a note on the guitar, the indicator in the display of the Control One will move either to the right, or the
left. If the indicator is moving right, the note you are playing is sharp. If the indicator moves left, you are flat.The goal
is to tune your guitar so that the indicator stops in the middle and the display locks-in, indicating you are in tune.
• In both methods of tuning, the tuner is referenced to A=440Hz. If you prefer tuning sharp or flat according to the A
reference, use the <3> knob to select a new reference.This can be set as high as A=453Hz or as low as A=427Hz.
The tuner can also be used for alternate tuning references where A=Ab (meaning you play an A note, but you hear
an Ab note). It is possible to tune as low as A=Gb.
• At this point, press any footswitch on the Control One to exit the Tuner mode.
To Next Page
Loading...
Need help?
General
