58
BANK UP/ TUNER AND BANK DOWN /
BYPASS FOOTSWITCHES
These two footswitches are located at the far right side
of the Control One next to the Expression pedal.The
Bank Up/Tuner footswitch, as you may have guessed, will
move to the next Bank Up in the 2112, as well as access
the Tune Mode by simply pressing and holding the
footswitch until the Tuner appears in the display.
To access the next bank down press the footswitch
once.To bypass the 2112, press and hold the footswitch
until the LEDs indicate that the unit is now in bypass
mode.
NOTE:The tuner information found on the front of
the 2112 is also sent to the Control One foot con-
troller for convenient tuning in live situations.
N
AMING BANKS
Straight out of the box, the 2112 has 19 user Banks to
choose from when used with the Control One foot
controller. Each of the Banks have been given a specific
named to give indication to what type of programs exist
with the Bank. In your constant editing mode to make
the box custom to your needs, we have given you the
ability to rename the Banks.The procedure is as follows
(and please don’t worry, we won’t be hurt):
• From Program Mode press the <Utilities> button and
the display will appear something like this:
•
T
urn <Page> knob until the displa
y reads:
• At this point, use the <2> knob to select the Bank to
be named. Once the Bank has been selected, turn the
<4> knob to rename the Bank. The display now
appears like this:
• To exit the Transmit channel assignment, press the
<Utilities> button.
• Using the <1> knob, change the character to the
one you want in the selected position.
• When the correct character is displayed in that posi-
tion,
use the <Page>
knob to scroll the cursor to the
next character you want to change.
• Use the <2> knob to select numbers, the <3> knob to
insert spaces and the <4> knob to copy and paste
characters.
• To copy a character, position the cursor under the
character you want to cop
y (using the <Page>
knob),
then turn the <4> knob clockwise.To paste the copied
character, position the cursor where you want to paste
the character, then turn the <4> knob counter-clock-
wise.
•
T
o abort the procedure,
push either the <Program>
button to take you to Program Mode, the <Edit> but-
ton to take you to FX Edit Mode, or the <Utilities>
button to take you to Utility Mode, depending upon
which mode you want to enter.
To Next Page
Loading...
Need help?
General
