29
TUBE DISTORTION PARAMETERS
Dist On/Off/Bypass Turns the Tube Distortion module either On/Off or Bypasses the Module.
Distortion Type Selects the the type of distortion that is being used in the program.The Tube DIstortion
types include: Warm Clean- Ideal for clean tone, Bright Clean- Great for mellow blues,
Dirty Tube- Overdriven blues solos or dirty Rhythm tones, Saturated Tube- Heavily sat-
urated tube amplifier voicing
Distortion Gain Controls the amount of gain being used in the selected distortion type.This parameter
value ranges from 0 to 100.
SOLID S
TATE DISTORTIONS
It seems that in this day and age, the great controversy is no longer Roe vs.Wade, it seems to be more of Tube vs.
Solid State distortions.The 2112 believes that these two effects can live together in harmony under the same chassis
lid.The Solid State distortions available in the 2112 offer variety and yet still compliment the Tube distortions.
SOLID STAT E DISTORTION PARAMETERS
On/Off/Bypass This parameter turns the Solid State distortion On/Off or Bypasses the effect module.
Distortion Type This parameter allows you to select which Solid State Distortion type is being used.The
Solid State Distortion Types are: Grunge- Industrial music industry standard, Fuzz- Fuzz-
face type emulation, Overdrive - Classic distortion screamer, and Heavy Sustain- Heavily
saturated soloing tones.
Distortion Gain Controls the amount gain being used in the in the selected distortion type. This value
ranges from 0 to 100
TUBE AND SOLID STATE DISTORTION PATH ANALOG 10-BAND GEQS
Included in every program of the 2112 Tube and Solid State distortion paths, is a 10-band graphic EQ with 12 dB
boost or cut in 1 dB increments. Note: This EQ is separate from the Global/Local EQ and EQ effect modules used
in Program mode.
NOISE REDUCTION
The Silencer II noise reduction system is definitely going to become your best friend in any recording session or live
performance for keeping signals quiet. Along with being quiet, the Noise reduction can be placed in several different
spots within the signal path of the 2112.This feature is great to use when extra noise reduction is needed in different
areas.
NOISE REDUCTION PARAMETERS
Type Selects the type and placement of the noise reduction to be used.Types include: 1. Silencer
1 pre T&D, 2. Silencer II post T&D, 3. Silencer II post Tube, 4. Silencer II post Solid State dis-
tortion.
Threshold Set the minimum input level at which the compressor will engage. Ranges from -90 to 0.
Attenuation Adjusts how far the signal is lowered when the gate is closed. Ranges from 1 to 5.
Attack Controls how quickly the gate opens after the signal level reaches Thresh. Range: 1 to 10.
Release Determines how quickly the the gate closes after the signal falls below the Threshold.
Ranges from: 1 to 10.
To Next Page
Loading...
Need help?
General
