Dini Argeo DFW - Connecting External Power Supply 110-240 Vac; Battery Power; Charge the Internal Battery Rechargeable

WIRING AND POWER
10
3.2.2 CONNECTING EXTERNAL POWER SUPPLY 110-240 VAC
Connect the power supply to the mains (110-240 VAC) and the plug to the socket on the indicator.
Example 1
Plug power supply Socket on the indicator
Esempio 2
Plug power supply Socket on the indicator
3.3 BATTERY POWER
The instrument may provide for the use in battery (refer to the table in paragraph 2).
In this case you can use the tool even without mains supply, using this only for the possible charge (in case
of internal rechargeable battery).
3.3.1 CHARGE THE INTERNAL BATTERY RECHARGEABLE
To recharge the battery, connect the instrument to the network as described in the previous paragraph.
The battery must be supplied by the manufacturer.