Dini Argeo DFW - Unit of Measure Conversion; Net;Gross Weight Switch; Set Point Configuration

SELECTABLE OPERATING MODES
34
- HORIZONTAL TOTALIZER
- VERTICAL TOTALIZER
- PIECE COUNTING.
The operating mode is selectable in the Setup environment ( ).
8.1 UNIT OF MEASURE/POUNDS CONVERSION ()
By pressing the MODE key the weight conversion between the scale unit of measure and lb is
made and vice versa.
NOTES:
- The conversion takes place for any unit of measure set during the calibration.
- With APPROVED instrument the weight in pounds is displayed for 5 seconds, after which the
display goes to the scale unit of measure. During the viewing in pounds it is not possible to
print the weight (when pressing ENTER/PRINT the message “” is shown and an acoustic
signal is emitted).
8.2 NET/GROSS SWITCH ()
If a tare is set by pressing the MODE key, for about 3 second interval, the gross weight is displayed.
While the gross weight is being viewed it is not possible to print.
8.3 SET POINT ON THE GROSS OR ON THE NET WEIGHT ( / )
By selecting this mode, the instrument can handle up 4 to 4 relay outputs according to the weight set for
the activation / deactivation of external device (for example, to manage a dosage)
8.3.1 OPERATION
Introduce for each relay outputs a ENABLING SET POINT, that, when the weight is greater or equal to it,
activates the concerned relay and when the weight is less, turn off the concerned relay.
If necessary, it is possible to at a value lower than that of activation, enabling the HYSTERESIS function in
the SETUP.
In this case it will be requred during the insertion phase, also the DISABLING SET POINT.
8.3.2 INSERTING SETPOINT
Holding down the ENTER/PRINT key for about 3 seconds, introduce the values of DISABLING and ENABLING
set point, only for the configured relays output :
- The display shows "" (DISABLING relay 1 SET POINT): press ENTER/PRINT to enter the step.
- Enter the value in the numeric keypad, or as described in “NUMERIC INPUT WITH THE 5-KEY KEYPAD”
and confirm with ENTER/PRINT
- The display shows "" (ENABLING relay 1 SET POINT): enter the weight value like in the preceding
SET POINT and confirm with ENTER/PRINT.
- With the C key, one quickly zeros the set point value.
- In the same way go ahead with the “”, “”, “”, “”, “”, “” (if