Dini Argeo DFW - Vertical Totalizer (Sum by Recipe); Piece Counting

SELECTABLE OPERATING MODES
44
A value of 0 disables the function.
The changed parameters are not stored permanently in the memory of the indicator; if you want to
permanently store these settings, you must edit in the indicator’s SETUP.
8.11.6 MEMORY STORAGES (only for 17-key indicator)
It is possible to memorize the weigh totalisation in one of nine memory storages (identified from 1 to 9):
- Press in sequence the F and 5 keys; the display shows "  ":
- Enter the desired storage number (from 1 to 9).
- Now all the made totalisations are stored in the storage number just entered.
- To change the storage, repeat the same operations.
To recall or zero the PARTIAL TOTAL of a storage, it is necessary to recall first its identifying number, as
previously described; however the GRAND TOTAL is not available for each storage.
All values accumulated in the individual registers are automatically zeroed each time that the instrument is
turned off; it is possible to permanently store this data if the instrument is fitted with the date/time option.
8.12 VERTICAL TOTALIZER (Sum by recipe) ()
In this mode it is possible to totalize a weight as described in the operating mode “HORIZONTAL
TOTALIZER”, but at each totalisation the indicated weight is totaled and automatically put in tare; in this
way it is possible for example to fill for example a container with different products.
At the end of the operations of totalisation, if you want to display the gross weight on the scale is necessary
to cancel the TARE as described in the paragraph “CANCELLING A TARE”.
8.13 PIECE COUNTING ()
Using this operating mode, it is possible to use the scale as piece counting.
8.13.1 COUNTING PROCEDURE WITH REFERENCE
With the 5-key indicator
1) Place the empty container on the scale and press TARE to tare it.
2) Check that the zero is on the display and press the MODE button: the counting function is enabled.
3) The display suggests a REFERENCE QUANTITY. The possible options are: 5, 10, 20, 30, 40, 50, 60, 75,
100, 200.
4) Press “ZERO” or “TARE” the number of times needed to reach the desired sample size.
5) Put the quantity of pieces chosen for the sample on the scale and press ENTER/PRINT to confirm or C
to cancel the operation and return to weighing.
6) Press ENTER/PRINT; the display will indicate "" the indicator will calculate the Average Piece
Weight (APW). After a few instants the display will indicate the quantity selected put on the platform.