Dini Argeo DFW - 4 Turning on; off the Instrument; Turning on; Autozero at Start-Up; Turning off

TURNING ON / OFF THE INSTRUMENT
13
4 TURNING ON / OFF THE INSTRUMENT
4.1 TURNING ON
TO TURN ON the instrument press the C key until the indicator turns on; then release.
The display shows
 is the installed software version
The instrument turns on all the display segments and symbols
Then displays
 range of channel 1
(or  if you select the operating mode “”, or  if you select the
operating mode “”)
 where  is a number from 0 to 100 that indicate the battery level in percentage.
After this, it shows the programmed capacity and the minimum division, "" (in case of NOT approved
instrument) or “" (in case of approved instrument), the g gravity value, and finally it executes a
countdown (self-check).
4.2 AUTOZERO AT START-UP
The indicator has an “auto zero at start-up” function: in other words it means that if at start-up a weight
within +/- 10% of the capacity is detected, it will be zeroed; if the weight is not within this tolerance, with a
non approved instrument the display shows the present weight after a few instants, while with an
approved instrument “” is shown continuously on the display, until the weight does not re-enter
within this tolerance; the auto zero function at start-up may be disabled in the set-up environment (only
with non approved instrument); see:
 >>  >>  >>  ( ).
4.3 TURNING OFF
TO TURN OFF the instrument keep the C key pressed until the ““ message appears on the
display; then release the key.
TO RESTART the instrument keep the C key pressed for 8 seconds long: the indicator will turn off, then
release the key and the indicator will automatically turn on.