Dini Argeo DFW - Totalisation with Printing; Printing and Zeroing of the Totals; Field of Totalisation and Automatic Print of the Partial Total

SELECTABLE OPERATING MODES
43
8.11.3 TOTALISATION WITH PRINTING
If it has configured the presence of a printer at the execution of the weigh will be run a print showing also
the number of weighing, in addition to the data programmed in SETUP .
8.11.4 PRINTING AND ZEROING OF THE TOTALS
The instrument has two different total levels, a partial total and a general total, which increase upon each
totalisation; these may be printed and zeroed independently from each other.
To print and zero the PARTIAL TOTAL one should press for an instant the ENTER/PRINT key; depending on
the type of totalisation, various messages will be displayed:
- With normal totalisation the number of weighs and the accumulated total will be displayed.
- With fast or automatic totalisation the message “”will be displayed.
The number of weighs made and the NET WEIGHT PARTIAL TOTAL are printed.
To print and zero the GENERAL TOTAL one should press for a few seconds the ENTER/PRINT key:
- With normal totalisation, the “” message and then the number of weighs and the accumulated
total will be displayed.
The number of weighs made and the NET WEIGHT GENERAL TOTAL are printed.
NOTE: The printed data remain in any case until the next printable totalisation.
8.11.5 FIELD OF TOTALISATION AND AUTOMATIC PRINT OF THE PARTIAL TOTAL
In weighing you can quickly change the following parameters by pressing the MODE key 2 times
consecutively:
(!) 000.000Min.WGttot o / tot S
MAX.WGt (!) 000.000
MAX.tot
(!) 00
Press the TARE and the ZERO keys to select the parameter and the ENTER / PRINT key to select it and then
set the value via the numeric keypad or as described in the paragraph “NUMERIC INPUT WITH THE 5-KEY
KEYPAD”
: MINIMUM WEIGHT FOR THE TOTALISATION.
Minimum weight that must be present on the scale to be able to run a totalisation.
: MAXIMUM WEIGHT FOR THE TOTALISATION.
Maximum weight that must be present on the scale to be able to run a totalisation.
: NUMBER OF CONSECUTIVE TOTALISATION FOR PRINTING AND AUTOZERO OF PARTIAL TOTAL
After making the set weighs, is printed and reset the general total automatically accumulated; set a value
between 0 and 63.