SELECTABLE OPERATING MODES
33
cancelled.
- In the TOTALIZER functioning mode, the codes will be printed only in the printing of the total.
7.2.1 LOCKED / UNLOCKED CODE SELECTION
Normally the code is LOCKED, in other words once it is set it remains stored (and therefore printed) until it
is cancelled or until the instrument is turned off. In any case it is possible to make it so the code is cancelled
as soon as it is printed (UNLOCKED CODE):
- Press the keys “F” + “4” in sequence; the display indicates "
".
- Press "1"; the display indicates "
", this means that the CODE 1 will be UNLOCKED.
- Press the same keys again: the display indicates "
", this means that now the CODE 1 will be
LOCKED.
- Repeat the same operations for CODE 2.
7.3 REPETITION OF THE LAST PRINTOUT MADE
Press in sequence the F and PRINT keys: the last printout made by the indicator will be repeated.
NOTES:
- By turning off the instrument, the information relative to the last printout made, will be lost; therefore
this function is not enabled until the first printout is made.
- This function is available only in the DFW type indicators.
8 SELECTABLE OPERATING MODES
PREMISE: For the indicator functions in the “Weight repeater” , refer to the section “HOW TO USE
INDICATOR AS WEIGHT REPEATER”.
In addition to the standard weighing mode with TARE subtraction and transmission of data, the indicator
can carry out one of the following functions:
- UNIT OF MEASURE/POUNDS CONVERSION
- NET/GROSS SWITCH
- SET POINT ON THE GROSS WEIGHT
- SET POINT ON THE NET WEIGHT
- IN/OUT, SINGLE - MULTISCALE REPEATER
- APPROVED TRANSMISSION OF WEIGHT TO PC WITH ALIBI MEMORY
- +/- TOLERANCE CHECK
- SAMPLE WEIGHT PERCENTAGE
- SINGLE SCALE REPEATER
- DISPLAY WITH SENSITIVITY X 10
- FREEZING OF THE WEIGHT ON THE DISPLAY
- PEAK DETECTOR
To Next Page
Loading...
