Dini Argeo DFW - Weighing and Printing Conditions

BASIC FUNCTIONS
30
detected, or a key is pressed, the indicator returns to view the current weight.
6.10 CONDITIONS FOR PERFORMING THE WEIGH AND PRINTS
If a printer is connected, it is possible to print the programmed weight data, for example:
- 4 heading lines of 24 characters
- GROSS weight
- TARE weight
- NET weight
- ticket number
- date and time (optional or included depending on the model)
- a CODE 39 bar code (both with the LP542PLUS labeller as well as the TPR thermal printer).
Besides the generic printing described above, each single functioning mode will have some specific
printouts, which are described in the operating mode.
It is also possible to send weigh data to the PC, with standard or extended string, via the printer port
(selecting / o / in the “” parameter).
6.10.1 EXECUTING PRINTOUTS WITH NON APPROVED SCALES.
Normally, with non approved scales, the conditions of printing are the following:
- the weight must be stable;
- the gross weight must be >= 0;
- the printout is always active.
In the totalizer mode and input / output instead, in order to print the totalised weight the following must
take place:
- the weight must be stable;
- the net weight must be >= of a division with normal or fast totalisation;
- the net weight must be >= of 10 divisions with automatic totalisation;
- weighing needs to be reactivated, as describe in the section “REENABLING OF PRINTS”.
6.10.2 LEGAL FOR TRADE SCALES PRINTING.
In order to be able to print with a legal for trade scale the following conditions must exist:
- the weight must be stable;
- the net weight must be >= the minimum weight (minimum of 20 divisions);
- weighing needs to be reactivated, as describe in the section “REENABLING OF PRINTS”.
6.10.3 NOTES ON THE PRINTS
- The printing is confirmed by the indication on the display of the "" message or “”in case of
totalisation.
- If the printout is not reenabled the display shows the "" message
- With the weight unstable the display shows the "" message.
- If the gross or net weight is less than the requested minimum weight, by pressing the ENTER/PRINT key,
the display shows the “”error message.
- If the indicator is in under load or over load status, by pressing the ENTER/PRINT key, the display shows
the “”error message.
To configure the printouts, go to the section “PROGRAMMING THE PRINTOUTS” in the technical manual