BASIC FUNCTIONS
31
( ).
6.11 REENABLING THE PRINTOUTS AND THE INDICATOR FUNCTIONS
While using the indicator, it is possible to incur into the “”error shown on the display along with
an acoustic signal; this means that the printing or the function which one wants to carry out must be
reenabled (in order to avoid unwanted executions).
This function is very useful for avoiding unwanted weight or build-up.
It is possible to set the reenabling in different ways ( ):“passage by zero of the net weight”, “weight
instability” or “always”.
6.12 DISPLAY OF METRIC DATA (info)
The indicator is fitted with a function named “”, thanks to which it is possible to view the
configuration metric data:
- With the 5-key indicator:
- keep the C key pressed until the display shows “”, and release, or:
- press the keys MODE + C keys in sequence.
- With the 17-key indicator:
- press the key i once, or:
- press the keys MODE + C keys in sequence, or:
- keep the C key pressed until the display shows “”, and release.
- The capacity value of the first range will appear.
- Press the ZERO key to scroll the following data, in this order:
Capacity 1° range Minimum weigh 1° range Division 1° range
Capacity 2° range Minimum weigh 2° range Division 2° range
Capacity 3° range Minimum weigh 3° range Division 3° range
Capacity 1° range ………
- Press the TARE key to scroll backwards the metric data.
- Press the C key to return to weighing.
NOTES:
- The minimum weigh corresponds to 20 net weight divisions.
- The data of the second and third range appear only if actually configured.
To Next Page
Loading...
Need help?
General
