USE THE INDICATOR AS WEIGHT REPEATER
51
Print of the weighs list: pressing the ENTER/PRINT key, the message “” appears,
pressing the ENTER/PRINT key to confirm (the message “” appears) or the C key to
exit from the step without print.
If confirm with ENTER/PRINT but the list is empty, the message “” appears.
Clearing of the list from the memory: pressing the ENTER/PRINT key, viene the message
“” appears, press the ENTER/PRINT key to confirm (the message “” appears) or
the C key to leave the step without erasing the memory.
Selection of a slave or of the sum: pressing the ENTER/PRINT key, the display shows the
“” message, then it will be possible to enter the number of the slave or the value
“” to select the sum of weights. This step appears only if multiple slave are set in the step
“”.
It allows to turn off only the master by pressing the ENTER/PRINT key.
Pressing the C key to exit from menu.
9.2.7 TURNING OFF THE MASTER AND SLAVES
If the MASTER displays the sum of the weights:
- pressing long the C key on the MASTER this will be turned off.
- to turn off the SLAVE you must press the button C on the SLAVE.
If the MASTER repeat a single SLAVE:
- It is possible to turn off the SLAVE pressing the C key on the MASTER until the message ““ appears
or pressing long the C key directly on the SLAVE.
- It is possible to turn off the MASTER pressing the C key on it until the message “” appears for the
second time.
If the MASTER is displaying the “” message, pressing long the C key on the MASTER this will be
turned off.