USE THE INDICATOR AS WEIGHT REPEATER
50
- scale number or text indication “”
- indication of PARTIAL TOTAL indicated by an asterisk next to the number of scales or text “”
- date and hour
- net weight (equal to the gross weight, even if the tare is done)
- tare weight (always equal to zero).
INITIALIZATION OF MEMORY
For the operation of the weighing list with a new memory, it must perform the initialization of it , otherwise
if try to save the weight, the message“” appears.
For the initialization, make reference to “LIST WEIGHS MANAGEMENT”.
STORING THE WEIGHT
Pressing the ENTER/PRINT key the current weight value is stored in the list.
If MASTER is in sum viewing, i twill store the sum of weights.
PARTIAL TOTAL STORAGE
If the function is enabled in SETUP, it is also possible to store the sum of stored weights to that point by
holding down the ENTER/PRINT key:
- The display show the “” message
- press ENTER/PRINT to confirm: display show the message “” and then the sum of the previous
stored weighs, flashes for five seconds, then the instrument returns to weighing.
- Pressing the C key the storage is canceled.
WEIGHS LIST MANAGEMENT
The weighs list management depends on the setting in SETUP.
It is possible to decide whether to allow the management only from PC, or allow it both on PC and on the
instrument:
In the first case, pressing long the ENTER/PRINT key, the master activates direct access to the connection
to PC, the message “” appears:
- The reading and inizializating of the list of weights, will only be possible on PC through the
software WeighConsole™. For the procedure, refer to the software manual of DiniTools™.
or
- It can send serial commands to the indicator to manage the memory (described in the
paragraph “FORMAT OF SERIAL COMMANDS”, )
If the list is empty, the message “” appears and the indicator is not connected to the PC.
By pressing any key the connection turned disable (appears the next step in the menu); to reactivate it,
must select the step “” and press ENTER/PRINT.
In the second case, pressing long the ENTER/PRINT key, it is possible to access to a menu: the display shows
the first step.
With TARE and ZERO keys it is possible to select one of the following steps and confirm with ENTER/PRINT:
Step for the PC connection: pressing ENTER/PRINT the connection is activated, the
management mode of the list are as described above.
To Next Page
Loading...
