Dini Argeo DFW - INSTRUMENT MESSAGES WHILE IN USE; Instrument Messages and Error Codes

INSTRUMENT MESSAGES WHILE IN USE
52
10 INSTRUMENT MESSAGES WHILE IN USE
MESSAGE
DESCRIPTION

The scale is zeroing the weight.

It is displayed when one selects the alibi memory functioning mode, and upon start-up,
the alibi memory is not connected or there are communication problems between the
indicator and the board. The “unit of measure/pounds conversion” functioning is
automatically set, but not saved in the set-up environment.

A function has been linked to input X (from 1 to 4) and this is not present; see the
“” parameter of the set-up environment ( ).

In a set point functioning mode the relay X has been set (from 1 to 4) and this is not
present; see the “” parameter of the set-up environment ( ).

Print under way (PRN serial port is occupied) or indicator waiting to transmit a printing to
a PC.

One is trying to print with an unstable weight.

One is trying to print with the weight in underload or in overload, in other words, with a
weight of 9 divisions greater than the capacity or of 100 divisions below the gross zero.

Weight less than the minimum weight provided for the printing, the totalisation or the
transmission of the string, standard or extended, upon pressing of the print key.

Weight not passed by net 0 or by instability.

In standard mode, with approved instrument, one is trying to print while the instrument is
converting the unit of measure.

In the input/output mode (set as “”), one is trying to acquire a second time the
input weight.

In the input/output mode (set as “”),one is trying to acquire a second time the
output weight.

In the input/output mode (set as “” or “”),one is trying to acquire a second
time the input weight.

In the input/output mode (set as “” or “”),one is trying to acquire a second
time the output weight.

Unstable weight.

In the counting mode, the sampling has not been made because one should use a higher
reference quantity.
In the equalization procedure, the cell that is being equalized is not the cell with the
greater weight.

It is displayed if it was not possible to perform the equalization.

It is displayed when data is stored in the permanent storage of the instrument (setpoint,
tares, etc.)

Communication problems with the date/time of the indicator: check the
>> step of the set-up ( ).