Dini Argeo DFW - Automatic Stand-by Function; Division of Flow in Multiple Fields; Remote Control Usage

BASIC FUNCTIONS
27
6.5 AUTOMATIC STAND-BY FUNCTION
It is possible to enable in SETUP ( ) the automatic stand-by function of the indicator.
The instrument is normally in stand-by (the display is turned off except for the point): at the pressure of any
button for an instant appears the message “”, then the weight on the scale is displayed for 30
seconds; after this time the instrument will return to stand-by.
6.6 DIVISION OF FLOW IN MOST FIELDS
(OPERATION IN MULTIPLE FIELDS)
The weighing system may provide for the division of the flow into multiple fields (up to three), thus
improving the division of the first and second field.
For example, a platform of 15 kg could be divided into three fields as follows:
Range
Flow
Division
1
from 0 to 3 kg
1g
2
from 3 to 6 kg
2g
3
from 6 to 15 kg
5g
The division is shown by the relative light or symbol on the display, which identifies the field in which you
are working; going from the first to the second field and from the second to the third field, its relative
division is automatically activate. At this point, the division of the first field resets, going from zero gross
scale.
6.7 REMOTE CONTROL (OPTIONAL)
If the indicator is shipped with remote control, is possible to use the functionality of the instrument keys.
There are two types of remote control: 19-key infrared remote control or radio remote control with 6
buttons.
The type of remote control that must be used and the mode of operation must be selected in setup
environment ( ).