Dini Argeo DFW - Horizontal Totalizer

SELECTABLE OPERATING MODES
42
8.11 HORIZONTAL TOTALIZER (Sum of lots) ()
In this mode it is possible to score a weight manually or automatically depending on the setting in the
setup.
8.11.1 TOTALISATION OPERATIONS
In order to carry out the totalisation it is necessary:
- to load the weight on the scale
- press the MODE key (if the automatic totalisation has not been set)
The weight is accumulated in two total levels (a partial total and a general total). The totals and the number
of weighs are zeroed when the instrument is turned off; it’s possible to store permanently these data if the
instrument is fitted with the date/time board option.
The totalisation follows the same conditions for the execution of weighing and printing, refer to the section
“CONDITIONS FOR PERFORMING THE WEIGH AND PRINTS”.
Also, if you press the MODE key with the following condition:
- unstable weight
- gross or net weight less than the minimum weight
- indicator in a state of overload or underload
- the totalisation remains pending: the blinking “” message is displayed and if the weight reaches
the stability within 10 seconds, the totalisation is executed, otherwise the totalisation is aborted and the
display shows the “”message and
- “” in case of weight is unstable
- “” the gross or net weight is less than the minimum weight
- “” if the indicator is in a state of overload or underload
8.11.2 DISPLAYIN PARTIAL TOTAL
With the 5-key indicator it is possible to view the weighs made and the PARTIAL NET TOTAL accumulated
up to that point (Subtotal) in 2 ways:
1) pressing long the MODE key
2) pressing the MODE key without having reactivated the totalisation.
The display shows the number of weighing, the message “” and then the total weight; if the
accumulated digit is greater than 5 digits viewing takes place in two phases
With the 17-key indicator, during the weighing, it is possible to view at any time the number of weighs and
the accumulated net weight in the totals:
- By pressing in sequence the F and 7 keys, the following will be displayed in this sequence:
o "", in which x is the number of weighs made
o "", followed by the accumulated PARTIAL NET TOTAL.
- By pressing in sequence the F and 6 keys, the following will be displayed in sequence:
o " ", in which x is the number of weighs made
o "", followed by the accumulated GENERAL NET TOTAL.