SELECTABLE OPERATING MODES
46
8.13.4 COUNTING WITH INTRODUCTION OF THE AVERAGE PIECE WEIGHT
It is possible to view or to enter through the keyboard a APW known to accelerate the reference
operations:
- With the scale at zero, after having stored a tare, press “F” + “6”, or the ENTER/PRINT key at length.
- The display will indicate "
" and then "" or a previously entered value expressed with three
decimal digits in the programmed unit of measure.
- Enter the APW value with the keyboard (or leave the one present) and press ENTER/PRINT to confirm.
Example
Unit of measure of the APW in g.
“000.000 means 000,000 g (for example APW = 001,050 = 1,05 g).
8.13.5 PIECE COUNTING IN EXTRACTION.
1) Load a FULL container on the scale and press "TARE" to tare it.
2) Press "MODE": The display suggests various REFERENCE QUANTITIES: 5,10,20,30,40,50,60,75,100, 200.
3) Press "ZERO" or "TARE" various times until the chosen quantity is displayed.
4) From the container take off the same number of pieces and press "ENTER/PRINT” to confirm. The
display shows "" while the indicator calculates the Average Piece Weight. The display shows in
negative the quantity extracted.
5) Continue the counting in extraction.
8.13.6 PRINTING IN THE COUNTING MODE
If it has configured the presence of a printer, at the execution of a weight through the ENTER/PRINT key, it
will run a print showing also the amount of PIECES (PCS) on the scale at that time and the average piece
weight.
To Next Page
Loading...
