Dini Argeo DFW - Page 18

FRONT PANEL KEYS AND INDICATORS
18
SCALE KEY
FUNCTION
ZERO
- Zeros the displayed gross weight, if it is within +/- 2% of the total capacity.
- Cancels the negative tare value.
- When entering numbers it decreases the digit to be modified.
TARE
- If pressed for an instant it carries out the semiautomatic tare.
- If pressed at length it allows entering the manual tare from keyboard.
- Cancels the negative tare value.
- In the numeric input phase it increases the digit to be modified.
MODE / 
- It carries out a specific function of the operating mode set in the set-up environment.
See paragraphs “MODE KEY FUNCTION / ” and “SELECTABLE OPERATING MODES”.
- In the numeric input phase it selects the digit to be modified, from left to right.
- In totalizator modes, if pressed twice consecutively, it allows to enter in a specific
menu to set the parameters of the totalizations.
ENTER / PRINT
- It carries out a specific function of the operating mode set in the set-up environment.
- In the numeric input phase, it confirms the entry made.
- In the SET-UP, it allows to enter a step or to confirm a parameter within a step.
- It transmits the data from the serial port dedicated to the printer.
C
- It turns the instrument on and off.
- In the numeric input phase, it quickly zeros the present value.
- In the set-up environment, it allows to exit a step without confirming the change
made.
F / Fn
- It allows to select the desired function, see sections “FUNCTION F / FN BUTTON IN
COMBINATION WITH NUMERIC KEYS” and “ADDITIONAL FUNCTIONS OF THE 17 KEYS”
- If pressed at length it allows to set the display intensity
( ),“” parameter).
i / .
- The “i” key allows to view the scale’s metric information: capacity, division, minimum
weigh for each configured range.
- In the numeric input phase it allows to enter the decimal point.
NUMERIC
KEYBOARD
- In the numeric input phase it allows to enter the desired value.