Page 18
AIM 2 Operation Manual
Powering Your Meter
Power-On
To turn on the AIM, press and hold the POWER button until the backlight turns on and
the meter sounds a tone. The meter turns on, briey displays a splash screen, and then
displays the HOME screen.
To start a job, press SETUP and follow the instructions in “Starting a Job” in Chapter 5.
Standby Mode
You can place your AIM in a power-saving state called
Standby mode. Standby mode lets you turn off the AIM
display and other features to extend the charge of the
battery. You can quickly exit Standby mode and resume
working on the screen where you left off.
Press and hold the POWER button until the SHUT DOWN
AIM screen appears.
Use the up/down arrow buttons to highlight Standby and
press OK. The meter enters Standby mode.
To exit Standby mode, press the POWER button.
Restart
Press and hold the POWER button until the SHUT DOWN AIM screen appears.
Use the up/down arrow buttons to highlight Restart and press OK. The meter turns off and
restarts.
To Next Page
Loading...
Need help?
General
