DirecTV Advanced Installation Meter 2 - Switch Type; Zip Code

Page 49
AIM 2 Operation Manual
Zip Code
1. On the MODIFY JOB SETUP screen, select Zip Code and press SELECT to go to the
ZIP CODE screen.
2. Use the numeric keypad to enter the zip code
for the job.
• To delete a character, press the Back
button. You also can use the left/right
arrow buttons to navigate within your
entry, or press CLEAR to delete the
entry and start over. Press CANCEL to
exit without saving changes.
3. When nished, press ENTER to return to the
MODIFY JOB SETUP screen.
Switch Type
1. On the MODIFY JOB SETUP screen, select Switch Type and press SELECT to go to
the SWITCH TYPE screen.
2. Select the type of switch for the job and press
SELECT.
• You also can press the number for an option
to highlight it.
• To exit without saving changes, press
CANCEL.
3. If the SWiM LNB is a module, you may also
have to select the channel conguration.
4. When nished, press SELECT to return to the
MODIFY JOB SETUP screen.
Make sure you set up the zip code correctly. It is required to
determine the thresholds for EIV testing.