Page 37
AIM 2 Operation Manual
IP Address
Once IP Settings is set to Manual, you can set
each of the network IP address values.
1. Select IP Address and press SELECT to go to
the IP ADDRESS screen.
2. Enter the IP address and press SELECT.
• To delete a character, press the Back
button. You also can use left/right arrow
buttons to navigate within your entry, or
press CLEAR to delete the entry and start
over. Press CANCEL to exit without saving
changes.
3. Press ENTER to save and return to the
ETHERNET SETTINGS screen.
Gateway, Netmask, and DNS Addresses
Select each of the other IP settings as necessary and modify using the steps above.
To Next Page
Loading...
Need help?
General
