Page 47
AIM 2 Operation Manual
Modifying the Setup for a Job
You can change the dish type, reverse band/international LNB, switch type, and zip code
settings for a new job or the current job from the MODIFY JOB SETUP screen. You also can
add notes for the job to include key information about the job, such as the specic room of the
installation.
To access the MODIFY JOB SETUP screen, press SETUP from the HOME screen.
Notes
1. On the MODIFY JOB SETUP screen, select
Notes and press SELECT to go to the NOTES
screen.
2. Using the keypad, enter the notes for the job.
• To delete a character, press the Back
button. You also can use left/right arrow
buttons to navigate within your entry, or
press CLEAR to delete the entry and start
over. Press CANCEL to exit without saving
changes.
• To enter only numbers, press NUMERIC. To enter letters and numbers, press
ALPHA. To enter capital letters, continue pressing the letter button until the capital
letter appears.
• To enter a space or a special character (such as -, #, &, or +), press the 1 button
repeatedly until the space or character you want to enter appears.
3. When nished, press ENTER to return to the MODIFY JOB SETUP screen.
To Next Page
Loading...
Need help?
General
