Page 46
AIM 2 Operation Manual
Starting a Job
To start a job, enter the account number for the installation. The AIM stores information about
the tasks you perform for the installation in records associated with the account number.
For the rst job at an installation, you also set the dish type, reverse band/international LNB,
switch type, zip code, and notes either by accepting the default settings (based on the previous
job), or by changing the default settings. See the Modifying the Setup for a Job section.
1. From the HOME screen, press SETUP to go to
the MODIFY JOB SETUP screen.
2. Select Account #. Then press the SELECT
softkey to go to the ACCOUNT NUMBER
screen.
3. Using the numeric keypad, enter the account
number for the job (up to 22 digits). Then press
ENTER.
• To delete a character, press the Back
button. You also can use the left/right
arrow buttons to navigate within your
entry, or press CLEAR to delete the
entry and start over. Press CANCEL to
exit without saving changes.
The MODIFY JOB SETUP screen reappears,
showing the account number you entered and
the default settings for:
• Notes
• DishType
• Reverse Band / International LNB
• Switch Type
• Zip Code
4. When nished, press DONE to return to the HOME screen. To install an ODU without
returning to the HOME screen, press INSTALL.
The default settings are based on the values entered for the
previous job.
To Next Page
Loading...
Need help?
General
