Dnepr MT10-36 - Page 88

check the pres · sure in the tyres and, if necessary, pump up the
tyres .
Do n
ot d isma ntl e the motorcycle and its units unless it is neces-
sa ry to do so; unneces sary dismantling and assemblage may disturb
the proper interaction of the parts and cause them to wear out too
fast or break.
List of compulsory maintenance jobs
Tools and
accessories
to be used
Daily Maintenance
Clean off dirt from the motorcycle
and was h it, if necessary. Motorcycle
ma y be washed only after the eng ine
cools. Close
the choke and air filter.
Do not direct the water jet at the ele-
ctrical equipment
an d bre ather plu gs
Mate r ials us ed
in maintenance
A~93 of gear box and main drive.
Check oil
and petrol level and, if ne-
cessary, fill up
Filler funnel
Petrol 7\-?6 v• A 72
GOST 2084 -67
Check fuel supply to carburettors an d
·operation of controls and signalling
equi pment
Check tyre pressure Tyre gauge
When checki
ng the motorcycle for
technical condition, pay special a tt en-
tion to the fastening of the handlebar,
to secu ring of the front fork in stee-
ring , column, tightening of wheel ax-
les,
tightening >Of generator nuts; also,
check
the wheels, tyres and brak es for
good condition,
make sure that the
fastenings secur ing the sidecar to mo-
torcycle
and the sidecar body to
chassis are re li ably tightened.
En gine operation is checked after star -
ting up and on the go.
Operation of
the brakes is checked on
the go.
When stopping en route, check the
wheel housings, crankcase,
gear box
a
nd main dri ve casings for overhea-
ting (to the touch). In case of over-
heating, find
th e cause and eliminate
it
Technical Servicing
No.
Carr y out daily maintenance jobs.
Check ignition advance
angle
Check the brakes for good condition,
clean the brake shoes
and working sur-
face of brake drums
Check spoke
tens ion and tighten, if
necessary
86
Driv e r' s
tools
Driv
er's
tools
Driv
er's
tools