dolycon CT100 Series - Page 109

CT100 inverter Detailed instructions of function parameters
105
F05.02
Parameter copy
Setting range: 0～1
Default
value: 0
0: reserved
1: reserved
F05.03
User password
Setting range: 0～65535
Default
value: 0
Protect the parameters of the inverter.
0000: no password protection.
1 ～ 65535: optional password. If you need to query and modify the inverter
parameters, you must enter a matching password, only after the password
verification, you can carry out the follow-up operation.
F05.04
Functions of MF key
Setting range: 0～4
Default
value: 0
0: left-shift key to switch display state
Combine with the “>>” key to switch the running or stop status monitoring
parameters.
1: jogging running
The key MF sends the jog run command.
2: FWD/REV switch
The key MF sends a command to switch the direction of the frequency command,
only valid for keypad control.
3: clear UP/DOWN setting
Clear the UP/DOWN setting.
4: non-factory parameter debugging
In this mode, you can only view the parameters that are not the same as the
default values, so that you can quickly check the settings of the inverter.
F05.05
Stop function of
STOP/RERST key
Setting range: 0～3
Default
value: 0
0: only valid for keypad control
1: valid for keypad and terminal control at the same time
2: valid for keypad and communication control at the same time
3: valid for all control modes