dolycon CT100 Series - Page 60

CT100 inverter Function parameters
56
verification and displays “0. 0. 0. 0. 0.”. You can enter only by inputting the
correct user password. For the factory setting parameter zone, only factory can
enter. (Remind that the users cannot modify the factory parameters by
themselves; otherwise, if the parameter setting is incorrect, damage to the
system may occur). If the password protection is unlocked, the user can modify
the password freely and the user password will be subject to the last one. When
F05.03=0, the user password is disabled.
5. When modifying the function parameters through 485 communication, the
function of user password follows the above rules.
List of function parameters
Function
code
Name
Detailed instruction of
parameters
Min. unit
Default
value
Modify
No.
F00 Group Basic function
F00.00
Motor control
mode
0: V/F control
1: speed sensorless vector
control
2: torque control (open loop
vector control)
1
0
☆
F00.01
Run command
channel
0: keypad run command
channel (LED off)
1: terminal running command
channel (LED flickering)
2: 485 run command channel
(LED on)
1
0
☆
F00.02
Main frequency
source X
0: keypad digit (F00.09)
1: keypad potentiometer AI0
2: analog input AI1
3: analog input AI2
4: HDI pulse input
5: process PID output
6: multi-step speed
7: simple PLC
8: 485 communication
1
0
○