Instructions for use Isolette 8000 plus SW 5.n 59
Assembly and preparation
6.8 Installing the breathing hose holder (accessory)
1 Insert the breathing hose holder (A) into one of the 4 support holes (B) on the
corners of the bed.
2 Ensure that the slot in the bottom of the holder aligns with the cross pin in the
support hole.
✓ When installed, the holder can be adjusted vertically and horizontally for
convenient positioning of breathing hoses.
When adjusting the breathing hose holder, make sure that it does not interfere
with the scale (if installed) to allow for correct weight measurements.
002
To Next Page
Loading...
